Replacing the USB Board
1. Using your index finger, route the USB connector into the USB connector slot in the computer base.
2. Rotate the USB board to the left under the routing guide on the computer base and keep it in place.
3. Align the hole on the USB board with the protrusion on the computer base.
4. Replace the screw that secures the USB board to the computer base.
5. Route the USB cable and connect it to the system board connector.
6. Replace the palm rest (see Replacing the Palm Rest).
7. Replace the power button board (see Replacing the Power Button Board).
8. Replace the keyboard (see Replacing the Keyboard).
9. Replace the center control cover (see Replacing the Center Control Cover).
10. Replace the optical drive (see Replacing the Optical Drive).
11. Replace the memory module(s) (see Replacing the Memory Module(s)).
12. Replace the module cover (see Replacing the Module Cover).
13. Replace the battery (see Replacing the Battery).
Back to Contents Page
To Previous Page
Loading...
