Next steps
1. Install the display bezel.
2. Install the hinge caps.
3. Install the display assembly.
4. Install the WLAN card.
5. Connect the battery cable.
6. Install the base cover.
7. Install the SD card.
8. Follow the procedure in after working inside your computer.
Camera
Removing the camera
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Disconnect the battery cable.
5. Remove the WLAN card.
6. Remove the display assembly.
7. Remove the hinge caps.
8. Remove the display bezel.
9. Remove the display panel.
About this task
Steps
1. Disconnect the camera cable from the camera module.
2. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
62
Removing and installing components
To Next Page
Loading...
