Steps
1. Place the power-button board into the slot on the palm-rest and keyboard assembly.
2. Install the single (M2x2) screws to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the IO board.
2. Connect the battery cable.
3. Install the base cover.
4. Install the SD card.
5. Follow the procedure in after working inside your computer.
Power button with fingerprint reader
Removing the power-button with fingerprint reader
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Disconnect the battery cable.
5. Remove the IO board.
About this task
The following images indicate the location of the power-button with fingerprint reader and provides a visual representation of
the removal procedure.
Removing and installing components
69
To Next Page
Loading...
