Removing the I/O Board | 31
Removing the I/O Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 9. For additional safety best
practices information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Prerequisites
1 Remove the battery. See "Removing the Battery" on page 10.
2 Follow step 1 to step 2 in "Removing the Memory Module(s)" on page 12.
3 Follow step 1 to step 2 in "Removing the Optical-Drive Assembly" on page 15.
4 Remove the keyboard. See "Removing the Keyboard" on page 21.
5 Remove the palm rest. See "Removing the Palm Rest" on page 24.
Procedure
1 Remove the screw that secures the I/O board to the computer base.
2 Lift the connector latch and, using the pull-tab, disconnect the I/O-board cable
from the system board.
3 Gently lift and remove the I/O board, along with its cable, off the computer base.
1 I/O board 2 I/O-board cable
3screw
OM_Book.book Page 31 Monday, June 10, 2013 3:30 PM
To Next Page
Loading...
