About this task
NOTE: The wireless-card antennas are attached to the speakers as an assembly and cannot be separated for individual
replacement. Services will replace the speakers and the wireless antennas as an assembly part.
The following image(s) indicate the location of the speakers and provides a visual representation of the removal procedure.
Steps
1. Release the latch of the keyboard backlit connector on the system board and disconnect the keyboard backlit cable.
2. Release the latch of the keyboard connector on the system board and disconnect the keyboard cable.
3. Release the latch of the touchpad connector on the system board and disconnect the touchpad cable.
4. Remove the speakers cable from the routing guides on the palm-rest and keyboard assembly.
5. Disconnect the speaker cable.
6. Lift the speakers along with their cables off the palm-rest and keyboard assembly.
40
Removing and installing components
To Next Page
Loading...
