Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
NOTE:
The palm-rest and keyboard assembly includes the following components:
● Palm rest
● Keyboard
● Wireless antenna (2)
Next steps
1. Install the touchpad.
2. Install the speakers.
3. Install the system board.
4. Install the power-adapter port.
5. Install the power-button board.
6. Install the power button.
7. Install the I/O board.
8. Install the coin-cell battery.
9. Install the fan.
10. Install the display assembly.
11. Install the battery.
12. Install the wireless card.
13. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
14. Install the memory module.
15. Install the base cover.
16. Follow the procedure in After working inside your computer.
Removing and installing components
53
To Next Page
Loading...
