mSATA Card (Optional) | 37
Replacing the mSATA Card
Procedure
1 Remove the new mSATA card from its packaging.
2 Align the notch on the mSATA card with the tab on the
system-board connector.
CAUTION: Use firm and even pressure to slide the mSATA card into place.
If you use excessive force, you may damage the connector.
CAUTION: To avoid damage to the mSATA card, never place cables under the
mSATA card.
3 Insert the mSATA card connector at a 45-degree angle into the system-board
connector.
4 Press the other end of the mSATA card down into the slot on the
system board and replace the screw that secures the mSATA card to the
system-board connector.
Postrequisites
1 Replace the base cover. See "Replacing the Base Cover" on page 20.
2 Replace the battery. See "Replacing the Battery" on page 13.
3 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 37 Monday, October 8, 2012 4:17 PM
To Next Page
Loading...
