support.dell.com System Software Solutions 4-3
&./!
(
You must install Windows 98 on the hard-disk drive, as described in the following
steps, before you install any device drivers:
1. Insert the Microsoft Boot Disk Windows 98 Series diskette into the diskette
drive.
2. Restart the computer.
3. When the
Microsoft Windows 98 Startup
menu appears, insert the Microsoft
Windows 98 CD into the CD-ROM or DVD-ROM drive.
4. Select
Start Windows 98 Setup from CD-ROM
and press <Enter>.
The Setup program runs ScanDisk to check your hard-disk drive.
5. When the hard-disk drive check is completed, type
to exit ScanDisk.
6. Follow the prompts on your screen to continue with the installation.
7. When prompted to create a start-up diskette, remove the Microsoft Boot Disk
Windows 98 Series diskette, and click
Next>
.
8. Label a blank, high-density diskette as instructed, insert the diskette into the
diskette drive, and then click
OK
.
9. Follow the prompts on your screen to complete the installation.
%)
(( &
All of your computer’s drivers for Dell-installed devices are operative when you
receive the computer. No further installation or configuration is needed. However, if
you ever need to reinstall any of these drivers, the driver files are provided on the
System Software CD.
Often device problems can be corrected by reinstalling the appropriate drivers. Also,
hardware manufacturers frequently provide updated drivers that support feature
enhancements or that correct problems. Obtain updated drivers for products pur-
chased from Dell from the support section of the Dell World Wide Web site
(
http://support.dell.com
).
%$$!$$#
$#
#
Before beginning this procedure, make sure that the external media bay containing a
CD-ROM or DVD-ROM drive is connected to the computer, and make sure that the
computer is connected to an electrical outlet.
To Next Page
Loading...
