Dell Inspiron 2000 - Page 97

support.dell.com Using the System Setup Program B-7

Parallel port When the option is
Enabled
, the
Mode
is
Bi-directional
,
the
Base I/O address
is
378h IRQ 7
. When the option is set
to
Disabled
, the port is disabled and you can use its
assigned LPT resources for another device. If you change
the parallel port address or DMA channel, be careful not to
create a conflict with the address or DMA channel of the
infrared port.
Local bus IDE con-
troller
Configures the integrated local-bus IDE adapter. Options are
Both
(default),
Disabled
,
Primary
, or
Secondary
. If
Both
is
selected, you can access both the hard-disk drive and the
media bay device(s). If
Primary
is selected, only the hard-
disk drive is accessible. When
Disabled
, the media bay
device(s) and hard-disk drive are disabled.
Modem Options are
Auto
(the default) and
Disabled
. Setting to
Auto
automatically configures the internal modem.
LAN Options are
Auto
(the default) and
Disabled
. Setting to
Auto
automatically configures the integrated NIC.
"$%176/)!$6'
& 
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the
system Help.