support.dell.com Using the System Setup Program B-9
Set User Pass-
word
Press <Enter> to set up a new user password, and then fol-
low the instructions on your screen. This password restricts
access to the computer.
Set Supervisor
Password
Press <Enter> to set up a new supervisor password, and
then follow the instructions on your screen. This password
can replace the user password.
Password on Boot When this option is enabled, you must enter a password
before the computer loads the operating system into
memory. Settings for this option are
Disabled
(default)
and
Enabled
.
Diskette access Specifies whether a
Supervisor
or
User
password is
required to access the diskette drive.
"$%!*,6'
&
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the
system Help.
To Next Page
Loading...
