Replacing the solid-state drive
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling
the hard drive.
Procedure
1 Slide the solid-state drive firmly into the slot at an angle and gently press
the solid-state drive down until it snaps into position.
NOTE: Ensure that the solid-state drive is firmly seated.
2 Turn the system board over.
3 Using the alignment posts on the top-cover assembly, snap the system-
board assembly into place.
Post-requisites
1 Follow the procedure from step 4 to step 5 in "Replacing the processor
fan”.
2 Replace the base cover.
43
To Next Page
Loading...
