Steps
1. Place the system board on the palm-rest and keyboard assembly.
2. Align the screw holes on the system board to the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x4) that secure the system board to the palm-rest and keyboard assembly.
4. Adhere the Mylar over the system-board screw that secures the system board to the palm-rest and keyboard assembly.
5. Connect the speaker cable to the system board.
6. Connect the keyboard cable to the connector on the system board and close the latch.
7. Connect the keyboard-backlight cable to the connector on the system board and close the latch, if applicable.
74
Removing and installing components
To Next Page
Loading...
