Steps
Place the power-adapter port into its slot on the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the wireless card.
4. Install the fan.
5. Install the M.2 2230 solid-state drive, if applicable.
6. Install the M.2 2280 solid-state drive, if applicable.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive, if applicable.
4. Remove the M.2 2280 solid-state drive, if applicable.
5. Remove the hard drive.
6. Remove the fan.
7. Remove the wireless card.
8. Remove the display assembly.
9. Remove the fingerprint-reader board.
10. Remove the touchpad.
Removing and installing components
77
To Next Page
Loading...
