Replacing the 2.5-inch hard
drives
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Place the hard drive into the hard-drive bracket and align the tabs on the
bracket with the slots on the hard drive.
2 Snap the hard-drive bracket into the hard drive.
3 Slide the hard-drive assembly into the slot on the side-chassis.
4 Connect the data cable and power cable to the hard drive.
5 Rotate the side-chassis towards the computer until it snaps into place.
6 Place the computer in an upright position.
Post-requisites
1 Replace the front bezel.
2 Replace the computer cover.
44
To Next Page
Loading...
