Removing the display hinges
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the wireless card.
4. Remove the display assembly.
5. Follow the procedure from step 1 to step 3 in "Removing the display back-cover and antenna assembly".
Procedure
1. Place the display-back cover and antenna assembly on a flat surface.
2. Remove the antenna cables from the routing guide on the display hinge.
3. Remove the six screws (M2.5x2.5) that secure the display hinges to the display back-cover and antenna assembly.
4. Remove the two screws (M2x3) that secure the display hinges to the display back-cover and antenna assembly.
5. Lift the display hinges off the display back-cover and antenna assembly.
34
62 Removing the display hinges
To Next Page
Loading...
