Removing the System Board | 41
5 Remove the screws that secure the system board to the computer base.
6 Lift the system-board assembly at an angle and release the system-board ports
from the slots on the computer base.
7 Lift the system-board assembly off the computer base.
8 Turn the system-board assembly over.
9 Remove the screws that secure the hard-drive interposer board to the
system-board assembly.
10 Disconnect the hard-drive interposer board from the system-board assembly.
11 Remove the fan. See "Removing the Fan" on page 44.
12 Remove the heat sink. See "Removing the Heat Sink" on page 46.
1 screws (5) 2 system-board assembly
1 screws (2) 2 hard-drive interposer board
book.book Page 41 Wednesday, October 2, 2013 3:11 PM
To Next Page
Loading...
