Dell Inspiron 580 - Memory Module(s); Memory Module Procedures

Back to Contents Page
 Memory Module(s)
Dell™Inspiron™580ServiceManual
Removing the Memory Module(s)
Replacing the Memory Module(s)
Recommended Memory Configuration
Setting Up Dual-Channel Memory Configuration

Removing the Memory Module(s)

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Locate the memory module(s) on the system board (see System Board Components).

4. Press out the securing clip at each end of the memory-module connector.

5. Grasp the memory module and pull it upwards.
If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the memory-module connector.
Replacing the Memory Module(s)

1. Follow the procedures in Before You Begin.

2. Press out the securing clip at each end of the memory-module connector.

3. Follow the memory installation guidelines (see Recommended Memory Configuration).


4. Align the notch on the bottom of the memory module with the tab in the memory-module connector.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
1
memory-module connector
2
securing clip
CAUTION: Do not install ECC memory modules.