Dell Inspiron 600m - Electrostatic Discharge Protection

Back to Contents Page
Fan
Dell™Inspiron™600mServiceManual


1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the keyboard.
3. Remove the palm rest.
4. Remove the microprocessor thermal-cooling assembly.
5. Pull straight up on the fan cable connector from the system board connector.


6. Remove the two M2.5 x 8-mm screws from the fan, and pull the fan away from the system board.
Back to Contents Page

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1
M2.5 x 8-mm screws (2)
2
fan
3
fan cable connector
4
system board connector