Adding and Replacing Parts 129
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside
the computer.
If you ordered a card with Bluetooth wireless technology with your computer, the card is already installed.
1
Follow the procedures in "Before You Begin" on page 109.
2
Loosen the captive screws in the modem/Mini-Card/wireless cover, and then remove the cover.
3
Remove the screw securing the card carrier.
4
Pull the carrier out of the compartment so that you can disconnect the card from its cable and remove
the card from the computer.
5
To replace the card, connect the card to the cable.
6
Then carefully insert the card into the carrier and insert the carrier into the compartment.
7
Replace the screw securing the card carrier into place.
1 screw 2 card carrier 3 card
4 card connector
1
3
4
2
To Next Page
Loading...
