Dell Inspiron 7000 - Page 32

2-4 Dell Inspiron 7000 Reference and Troubleshooting Guide
6\VWHP 7 LP H
System Time sets the computer to the time you specify (usually the current time).
Type in the appropriate information. Use the tab key to move between the hours, min-
utes, and seconds fields. This option is useful if you travel between time zones.
6\VWHP'D WH
System Date sets your system to the date you specify (usually the current date). Type
in the appropriate information. Use the tab key to move between the month, day, and
year fields.
)ORSS\'ULYH
Floppy Drive identifies the type of diskette drive being used by the computer. This
option has no user-selectable settings.
1.44 MB, 3 1/2” means there is a diskette drive in the options bay.
Not installed means that there is no diskette drive installed.
+DUG'LVN
Displays the capacity of the computer's hard-disk drive. If you install a drive with a dif-
ferent capacity, the settings under this option change automatically. This option does
not have any user-selectable settings.
4XLHW%RRW
When set to Enabled (the default), the diagnostic power-on self-test (POST) mes-
sages and summary screen do not appear at system boot. Disabled indicates that the
POST messages and summary screen do appear at system boot. In addition, if Quiet
Boot is enabled, you cannot choose a boot device as the system initializes.
9LGHR' LVS OD\ 'HYLF H
Allows you to specify whether video is visible only on the computer’s display (LCD
Mode), only on an external monitor or projector (CRT Mode), or on both the display
and an external device simultaneously (Simul Mode, the default).
When you are using Windows 98 (rather than the Setup program), press <Fn><F8>
to change the video display device.
7HOH YLVLR Q 7\SH
This option allows you to specify that a television is connected on the TV port. The
options are Disabled (the default), NTSC, and PAL.
6\VWHP0HPRU\
System Memory displays the base amount of dynamic random-access memory
(DRAM) installed in the computer. Each computer has 640 kilobytes (KB) of base
memory. This option has no user-selectable settings.