1-4 DellInspiron 7500 System Port Replicator User’s Guide
3. Place the computer on the port replicator platform, with the back of the computer
facing the port replicator’s docking connector, as shown in Figure 1-2.
Figure 1-2. Positioning the Computer on the Port Replicator
4. Position your fingers on the platform grips, as shown in Figure 1-3, and use your
thumbs to push the computer forward until the docking connectors are fully
engaged.
Figure 1-3. Docking the Computer
5. Turn on the computer.
Detaching the Computer From the Port
Replicator
Perform the following steps to detach the computer from the APR. The APR has a
power button and a safe undock button located on the right side of the port replicator.
NOTE: Do not use the power button located on the APR to turn off your computer
while it is attached to the APR. Doing so could result in data loss. Use the power but-
ton on the APR to turn on the computer only after it is attached to the APR.
computer
5498Tbk0.book Page 4 Friday, October 1, 1999 6:26 PM
To Next Page
Loading...
