Steps
1. Align the notch on the WLAN card with the tab on the WLAN card slot and insert the WLAN card at an angle into the WLAN card slot.
2. Connect the antenna cables to the WLAN card.
3. Align and place the WLAN card bracket on the WLAN card.
4. Replace the single screw (M2x3) to secure the WLAN card bracket to the WLAN card.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
Memory modules
Removing the memory module (single slot)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the memory module and provides a visual representation of the removal procedure.
Removing and installing components
21
To Next Page
Loading...
