Steps
1. Align the solid-state drive bracket to accommodate the M.2 2280 solid-state drive.
2. Slide the solid-state drive module firmly into the solid-state drive slot at an angle.
3. Place the solid-state drive module shield.
4. Replace the two screws (M2x3) that secures the solid-state drive module shield to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
Removing the M.2 2230 solid-state drive (SSD-1)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
NOTE: Slot 1 supports both M.2 2280 and M.2 2230 solid-state drives.
About this task
The figure indicates the location of the solid-state drive and provides a visual representation of the removal procedure of M.2 2280 SSD
from slot 1.
Removing and installing components
25
To Next Page
Loading...
