2. Pull the device by the latch release to remove the device from the module bay.
If the Device Screw Is Installed
1. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
2. Close the display and turn the computer over.
3. Use a #1 Phillips screwdriver to remove the M2 x 3-mm screw from the bottom of the computer.
NOTICE: To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them or
placing heavy objects on top of them.
To Next Page
Loading...
