116 Adding and Replacing Parts
www.dell.com | support.dell.com
8 If you are replacing a memory module, remove the existing module:
a Use your fingertips to carefully spread apart the securing clips on each end of the
memory module connector until the module pops up.
b Remove the module from the connector.
NOTICE: If you need to install memory modules in two connectors, install a memory module in
the connector labeled “DIMM A” before you install a module in the connector labeled
“DIMM B.” Insert memory modules at a 45-degree angle to avoid damaging the connector.
securing clips
(2 per connector)
memory module
To Next Page
Loading...
