Replacing the Optical Drive
1. Follow the instructions in Before You Begin.
2. Align the screw holes on the optical-drive bracket with the screw holes on the optical drive and replace the two screws.
3. Slide the optical-drive assembly into the optical-drive compartment until it is fully seated.
4. Replace the screw that secures the optical-drive assembly to the computer base.
5. Replace the battery (see Replacing the Battery).
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
