Dell Inspiron One 2305 - Rear Stand; Removing the Rear Stand

Rear Stand: Dell Inspiron One 2305/2310 Service Manual
file:///T|/htdocs/systems/InsOne2310/sr/sm/stand.htm[7/25/2012 10:24:49 AM]
Back to Contents Page
Rear Stand
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Rear Stand
Replacing the Rear Stand
WARNING: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to
servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on your computer).
Removing the Rear Stand
1. Follow the instructions in Before You Begin.
2. Remove the back cover (see Removing the Back Cover
).
3. Follow the instructions from step 2
to step 5 in Removing the Front Stand.
4. Remove the rear stand cover (see Removing the Rear Stand Cover
).
5. Lift the rear stand and remove the two screws at the bottom of the rear stand hinge.
6. Remove the three screws at the top of the rear stand hinge.
7. Slide the tab on the rear stand hinge out of the slot on the chassis and then lift the rear stand away from the
computer.
1 tab 2 rear stand hinge
3 screws (5) 4 rear stand