Rear Stand: Dell Inspiron One 2305/2310 Service Manual
file:///T|/htdocs/systems/InsOne2310/sr/sm/stand.htm[7/25/2012 10:24:49 AM]
Replacing the Rear Stand
1. Follow the instructions in Before You Begin.
2. Slide the tab on the rear stand hinge into the slot on the chassis.
3. Replace the three screws at the top of the rear stand hinge.
4. Lift the rear stand and replace the two screws at the bottom of the rear stand hinge.
5. Replace the rear stand cover (see Replacing the Rear Stand Cover
).
6. Follow the instructions from step 4
to step 5 in Replacing the Front Stand.
7. Replace the back cover (see Replacing the Back Cover
).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain
inside the computer. Failure to do so may result in damage to the computer.
8. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
To Next Page
Loading...
