3. Replace the system-board shield (see Replacing the System-Board Shield).
4. Follow the instructions from step 4 to step 5 in Replacing the Front Stand.
5. Replace the back cover (see Replacing the Back Cover).
6. Connect your computer and devices to electrical outlets, and then turn them on.
7. Enter the system setup utility (see System Setup Utility) and restore the settings you recorded in step 1.
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
