Dell Inspiron One 2310 Intel - Removing the Antenna-In Connector; Replacing the Antenna-In Connector

Back to Contents Page
 Antenna-In Connector
Dell™Inspiron™One2305/2310ServiceManual
Removing the Antenna-In Connector
Replacing the Antenna-In Connector


Removing the Antenna-In Connector

1. Follow the instructions in Before You Begin.

2. Remove the back cover (see Removing the Back Cover).

3. Follow the instructions from step 2 to step 5 in Removing the Front Stand.

4. Follow the instructions from step 4 to step 8 in Removing the System-Board Shield.

5. Remove the hex nut that secures the antenna-in connector to the system-board shield.

6. Release the antenna-in connector from the slot on the system-board shield.

7. Lift the antenna-in connector along with its cable away from the system-board shield.
Replacing the Antenna-In Connector

1. Follow the instructions in Before You Begin.

2. Slide the antenna-in connector into the slot on the system-board shield.

3. Replace the hex nut that secures the antenna-in connector to the system-board shield.

4. Follow the instructions from step 4 to step 8 in Replacing the System-Board Shield.

5. Follow the instructions from step 4 to step 5 in Replacing the Front Stand.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
antenna-in connector
2
hex nut