4. Using a hex nut driver, replace the two screws that secure the VGA connector to the I/O bracket.
5. Replace the chassis fan (see Replacing the Chassis Fan).
6. Replace the I/O bezel (see Replacing the I/O Bezel).
7. Replace the top bracket (see Replacing the Top Bracket).
8. Replace the top cover (see Replacing the Top Cover).
9. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
