Dell Inspiron Zino - Replacing the Memory Module(S)


3. Use your fingertips to carefully spread apart the securing clips on each end of the memory-module connector until the module pops up.

4. Remove the memory module from the memory-module connector.

Replacing the Memory Module(s)


1. Follow the procedures in Before You Begin.

2. Align the notch in the memory module with the tab in the memory-module connector.

3. Slide the memory module firmly into the slot at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear the
click, remove the memory module and reinstall it.

4. Replace the bottom cover (see Replacing the Bottom Cover).


5. Connect your computer and all attached devices to electrical outlets, and then turn them on.
If the message appears stating that memory size has changed, press <F1> to continue.

6. Log on to your computer.

7. To verify that the memory is installed correctly:
Windows
®
XP:
Click Start® ControlPanel® System.
Windows Vista
®
:
Click the Start button ® ControlPanel® SystemandMaintenance.
Windows 7:
Click the Start button ® ControlPanel® SystemandSecurity® System.

8. Check the amount of memory (RAM) listed.
Back to Contents Page

1
tab
2
memory-module connector
3
memory module
4
securing clips (2)
CAUTION: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM 1" before you
install a memory module in the connector labeled "DIMM 2."
NOTE: If the memory module is not installed properly, the computer may not boot.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.