Image: Touch-panel assembly
removal
1. Place the display assembly on a flat surface. Open the display hinge caps to 90 degrees and open the display hinges to 180
degrees.
2. Open the display-hinge caps to 180 degrees and place the display hinges over the edge of the table.
3. Use a plastic scribe to pry open the display assembly, starting from the U-shaped recesses near the hinges at the bottom
edge of the display assembly.
4. Pry open the bottom side of the display assembly.
NOTE:
Pry the touch-panel from the recesses located in the U-shaped indents near the hinges.
62 Removing and installing components
To Next Page
Loading...
