Table 9. System setup options—Connection menu (continued)
Connection
By default, the Bluetooth option enabled.
Enable UEFI Network Stack Enables or disables the UEFI Network Stack and controls the on-board LAN
Controller.
By default, the Enable UEFI Network Stack option is enabled.
Wireless Radio Control
Control WLAN Radio Enables to sense the connection of the computer to a wired network and then
disables the selected wireless radios (WLAN and/or WWAN). Upon disconnection
from the wired network, the selected wireless radios are re-enabled.
By default, the Control WLAN Radio option is disabled.
Table 10. System setup options—Power menu
Power
Battery Configuration Enables or disables the computer to run on battery during peak power usage
hours. Use the table Custom Charge Start and Custom Charge Stop, to
prevent AC power usage between certain times of each day.
By default, the Adaptive option is selected. Battery settings are adaptively
optimized based on your typical battery usage pattern.
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Enables Advanced Battery Charge Configuration from the beginning of the day
to a specified work period. When enabled, Advanced Battery Charged maximizes
battery health while still supporting heavy use during the work day.
By default, the Enable Advanced Battery Charge Configuration option is
disabled.
Peak Shift
Enable Peak Shift Enables the computer to run on battery during peak power usage hours.
By default, the Enable Peak Shift option is disabled.
Thermal Management Enables or disables cooling of fan and manages processor heat to adjust the
system performance, noise, and temperature.
By default, the Optimized option is selected. Standard setting for balanced
performance, noise, and temperature.
USB Wake Support
Wake on Dell USB-C Dock When enabled, connecting a Dell USB-C Dock wakes the computer from Standby,
Hibernate, and Power Off.
By default, the Wake on Dell USB-C Dock option is enabled.
Block Sleep Enables or disables the computer from entering Sleep (S3) mode in the operating
system.
By default, the Block Sleep option is disabled.
NOTE: When enabled, the computer does not go to Sleep, Intel Rapid Start
is disabled automatically, and the operating system power option is blank if it
was set to Sleep.
Lid Switch
Enable Lid Switch Enables or disables the Lid Switch.
By default, the Enable Lid Switch option is enabled.
System setup 89
To Next Page
Loading...
