Disassembly and reassembly
Disassembly and reassembly
Remove SD memory card and SIM card tray
1 Follow the procedure in Before working inside your tablet.
NOTE: disconnect the power and drain ea power before preforming the steps
2 Lay the tablet on a plane and at surface, with the kickstand facing upward.
3 Press the SD memory card to release it.
NOTE: Ensure to turn o or disconnect power, to drain ea power before removing or installing the memory card and/or
SIM card.
4 Slide the SD memory card out from the system.
5 To remove the SIM card tray from the system, insert a pin into the release hole to release the SIM card.
6 Remove the SIM card tray from the system.
Display Assembly
Removing the display assembly
1 Follow the procedure described in Before working on your tablet.
2 Open the kickstand by holding the tablet vertically and pressing it down. Place the tablet with the display facing down.
NOTE
: You can also open the kickstand from the speaker recess area.
NOTE: SIM card slot is available only on tablets shipping with WWAN module.
3 Place the tablet on a at surface and lift the stand to reveal the base of the tablet.
NOTE
: Ensure to open the kickstand to 145 degrees.
2
Disassembly and reassembly 7
To Next Page
Loading...
