Option Description
• 1 minute
• 5 minute
• 15 minute
• never
Touchscreen Allows you to controls whether the touchscreen is enabled or disabled. By default, the option is enabled.
Unobtrusive Mode Allows you to select the option. When enabled, pressing Fn+F7 turns o all light and sound emissions in the
system. To resume normal operation, press Fn+F7 again. This option is disabled by default.
Miscellaneous
Devices
Allows you to enable or disable various on board devices:
• Enable Camera This option is enabled by default.
• Enable Secure Digital(SD) CardThis option is enabled by default.
• Secure Digital(SD) Card read only mode
• Secure Digital(SD) Card Read-Only Mode
Video screen options
Option Description
LCD Brightness Allows you to set the display brightness depending up on the power source (On Battery and On AC).
NOTE: The video setting will be visible only when a video card is installed into the system.
Security screen options
Option
Description
Admin Password Allows you to set, change, or delete the administrator (admin) password.
NOTE: You must set the admin password before you set the system or hard drive password. Deleting the
admin password automatically deletes the system password and the hard drive password.
NOTE: Password changes take eect immediately.
By default, the drive will not have a password set.
System Password Allows you to set, change or delete the system password.
NOTE: Password changes take eect immediately.
By default, the drive will not have a password set.
M.2 SATA SSD-2
Password
Allows you to set, change, or delete the password on the system's M.2 SATA solid state drive(SSD).
NOTE: Password changes take eect immediately.
By default, the drive will not have a password set.
Strong Password Allows you to enforce the option to always set strong passwords.
Default Setting: Enable Strong Password is not selected.
82 System setup
To Next Page
Loading...
