Table 23. System Configuration(continued)
Option Description
• 1 minute
• 5 minutes
• 15 minutes
• Never
Touchscreen
This option controls whether the touchscreen is enabled or
disabled.
This option is enabled by default.
Unobtrusive Mode
When enabled, pressing Fn+F7 will turn off all light and sound
emissions in the system. Press Fn+F7 to resume normal operation.
Default is Disabled.
Fingerprint Reader
Enable or disable the Fingerprint Reader or the Fingerprint Reader
Device's Single Sign On capability.
• Enable Fingerprint Reader Device: Enabled by Default
• ENable Fingerprint Reader Single Sign On: Enabled by
Default
Miscellaneous devices
Allows you to enable or disable various on board devices.
• Enable Camera—Default
• Enable Secure Digital (SD) Card
• Secure Digital (SD) Card Boot—Disabled
• Secure Digital Card (SD) Read-Only Mode—Disabled
Video screen options
Table 24. Video
Option Description
LCD Brightness
Allows you to set the display brightness depending upon the power
source. On Battery (50% is default) and On AC (100% default).
Dynamic Backlight Control
This option enables or disables the Dynamic Backlight Control if the
panel supports the feature.
Security
Table 25. Security
Option Description
Admin Password
Allows you to set, change, or delete the administrator (admin) password.
The entries to set the password are:
• Enter the old password:
• Enter the new password:
• Confirm new password:
Click OK once you set the password.
NOTE: For the first time login, "Enter the old password:" field is marked to "Not set". Set
the password for the first time and later you can change or delete the password.
System setup 29
To Next Page
Loading...
