Dell M992 - 19" CRT Display

To Next Page

Dell™ M992 Color Monitor Quick Setup Guide 1

Dell™ M992 Color Monitor

Quick Setup Guide

Safety Instructions

Observe the following safety guidelines when connecting and using your monitor:

•

Be sure that your monitor is electrically rated to operate with the AC power available in your location.

•

Locate your monitor near an easily accessible electrical outlet.

•

Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or

touched with a sharp or abrasive implement.

• Put your monitor in a location with low humidity and a minimum of dust.

•

Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the power cable,

and keep the cable away from where people could trip over it.

•

Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.

•

To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the monitor's

case.

•

Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet.

•

Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openings should not be

blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface. Doing so may block the

ventilation openings in the bottom of the cabinet. If you put the monitor in a bookcase or some other enclosed space,

be sure to provide adequate ventilation.

•

Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it and contact an

authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth when necessary, but be

sure to unplug the monitor first.

•

If your monitor does not operate normally-in particular, if there are any unusual sounds or smells coming from it

unplug the monitor immediately and contact an authorized dealer or service center.

Connecting Your Monitor to a Computer

1. Turn off your computer and unplug your computer's power cable.

2. Connect the blue connector of the monitor's signal cable to the blue video connector on the back of your computer.

Tighten the connector screws finger-tight. Do not overtighten.

3. Fully insert the monitor power cable into the power port on the back of the monitor.

4. Plug the power cables of your computer and your monitor into a nearby electrical outlet.

5. Turn on your computer and monitor. If the monitor does not display an image, refer to the troubleshooting section of

this guide.

Need help?

Do you have a question about the Dell M992 - 19" CRT Display and is the answer not in the manual?

Dell M992 - 19" CRT Display Specifications

General

Screen Size	19 inches
Display Type	CRT
Maximum Resolution	1600 x 1200
Refresh Rate	85 Hz
Aspect Ratio	4:3
Dot Pitch	0.24 mm
Input Connectors	VGA
Vertical Refresh Rate	50-160 Hz
Recommended Resolution	1280 x 1024
Pixel Pitch	0.24 mm
Viewable Image Size	18 in
Horizontal Refresh Rate	30-96 kHz