Dell OptiPlex 170L - Processor; Replacing the Processor

Back to Contents Page

Processor
Dell™OptiPlex™170LUser'sGuide

Replacing the Processor

1. Follow the procedures in "Before You Begin."
2. Disconnect the cooling fan power cable from the FAN connector on the system board (see "System Board Components").
3. Disconnect the power cable from the 12VPOWER connector on the system board.

4. Pull up and rotate the airflow shroud.

5. Remove the heat sink:
a. Press the tab on the green securing clip to remove the clip from the retention base.


CAUTION: Before you begin this procedure, follow the safety instructions in the Product Information Guide.
CAUTION: The heat sink can get very hot during normal operation. Be sure that the heat sink has had sufficient time to cool before you touch it.
1
securing clip
2
tab