3. Align the notch on the bottom of the module with the crossbar in the connector.
4. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
5. Replace the computer cover.
6. Connect your computer and devices to electrical outlets, and turn them on.
7. The computer detects that the new memory does not match the existing configuration information and generates the following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
8. Press <F2> to enter system setup and check the value for System Memory.
To Next Page
Loading...
