Next steps
1. Install the WLAN card.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the solid-state drive.
4. Remove the WLAN card.
5. Remove the fan assembly.
6. Remove the heat sink.
7. Remove the memory module.
8. Remove the speaker .
9. Remove the processor.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
65 W system board
1.
M.2 WLAN connector 2. M.2 SSD PCIe connector (2230/2280)
3. Coin-cell battery 4. Optional video connector (VGA Port/DisplayPort 1.4a
(HBR3)/HDMI 2.0b Port)
Removing and installing components 51
To Next Page
Loading...
