3. Lift and remove the audio board with the cable off the display-assembly base.
Installing the audio board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image provides a visual representation of the audio board installation procedure.
Steps
1. Align the screw hole on the audio board with the screw hole on the display-assembly base.
2. Replace the screw (M3x5) to secure the audio board to the display-assembly base.
3. Connect the audio-board cable to the system board.
Next steps
1. Install the side-I/O board.
2. Install the speakers.
3. Install the rear-I/O bracket.
4. Install the bottom cover.
5. Install the wireless card.
6. Install the system-board shield.
7. Install the back cover.
8. Install the cable cover (optional).
9. Install the stand.
10. Follow the procedure in After working inside your computer.
Removing and installing components
75
To Next Page
Loading...
