2-22 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide
5 HFRQQHF W\RXUF RPSXWHUDQGSHULSKHUDOVW RWKHLUSRZHUVRXUFHVDQG
WKHQWXU QWKHPRQ
Booting your system with the PSWD jumper plug removed erases the existing
password(s).
( QW HUW KH6\VWHP6HWX SSURJUDPDQGYHULI\WKDWWKHSDVVZRUGLVGLV
DEOHG3URF HHGWR VWHSLI\ RXZDQWWRDVVLJQDQHZSDVVZRUG
NOTE: Before you assign a new system and/or setup password, you must
replace the PSWD jumper plug.
&$87,216HH´3URWHFWLQJ$JDLQVW(OHFWUR VW DWLF'LVFKDUJHµLQWKHVDI HW\
LQVW UXFW LR QVDW W KHIUR QWR IWKLVJXLGH
5HPRYHWKHFRPSXWHUFRYHUDFFRUGLQJWRWKHLQVWUXFWLRQVLQ´5HPRYLQJ
W KH &RPSXWHU&RYHUµLQ&KDSWHU
5HSODFHWKH3 6: 'MXPSHUSOXJ
5HSODFHWKHF RPSXWHUFR YHUDQGW KHQUHFRQQHFWWKHFRPSXWHUDQG
SHULSKHUDOVWRW KHLUSRZHUVRXUFHVDQGWX UQWKHPRQ
Booting with the PSWD jumper installed reenables the password feature. When
you enter the System Setup program, both password options appear as Not
Enabled, meaning that the password feature is enabled but that no password has
been assigned.
$VVLJQDQHZV\VWHPDQGR UVHWX SSDVVZ RUG
To assign a new system password, see “Assigning a System Password” found
earlier in this chapter. To assign a new setup password, see “Assigning a Setup
Password” found earlier in this chapter.
5HVSRQGLQJWR(UURU 0HVVDJHV
If an error message appears on your monitor screen while the system is booting,
make note of the message. Then, before entering the System Setup program, refer to
your
Diagnostics and Troubleshooting Guide
for an explanation of the message and
suggestions for correcting any errors. However, it is normal to receive an error mes-
sage the first time you boot the system after a memory upgrade. In that case, you do
not need to refer to the
Diagnostics and Troubleshooting Guide
; instead, refer to the
instructions in “Adding Memory” in Chapter 6 of this guide.
If you are given an option of pressing either <F1> to continue or <F2> to run the Sys-
tem Setup program, press the <F2> key.
To Next Page
Loading...
