Dell OptiPlex GX1 - Page 65

Using the ISA Configuration Utility 3-9
 &OLFN2.LQWKH&RQILJXUDWLRQ6HWWLQJVGLDORJER[ZKHQ\RXKDYHILQ
L V KHG  V H OHFW LQ J  UH VR XU FHV I R U WK H I XQ FWL R Q 
NOTE: After modifying the system configuration, you must turn off the system to
install, remove, or change jumper settings on the non-Plug and Play ISA expansion
cards to match the settings you selected in the ICU.
$GGLQJDQ8QOLVWHG&DUG
Unlisted cards are non-Plug and Play ISA expansion cards that do not have configura-
tion files stored in the ICU database.
NOTE: If you want to add a configuration file that you received on diskette with a new
expansion card, see “Adding a Listed Card” found earlier in this chapter.
To add an unlisted card with the ICU, perform the following steps:
  6WDUWWKH,&8DVGHVFULEHGLQ´6 WDUWLQJWKH,& 8µI RXQGHDUOLHU LQWKLV
F KDSWHU
  )URPWKH,&8ZLQGRZFOLFN$GGRUVHOHFW$GG& DUGIUR PWKH&RQILJXUH
PHQX
  & OLFNWKHQDPHRIW KHFDWHJR U\ RIFDUGWKDW\RXZDQW WRDGG,I\RX
F OLFNHG$GGLQ VWHS  FOLF N2.
A dialog box appears listing the names of all available cards of that type.
  6HOHF W8QOLVW HG&DUGIURPWKHERWWR PR IW KHOLVWRIFDUGVGLVSOD\HGLQ
WKH GLDORJER[ WKDWDSSHDUV7KHQFOLF N 2. 
  &OLFN1RZKHQWKH, &8DVNVLI \R XKDYHDFRQILJXUDWLRQILOHIRUWKHFDUG
The Configure Unlisted Card dialog box appears with blank fields.
  ( QW HUWKHQDPHRI WKHFDUGWKD W\RXZDQWWRDGGL QWKH& DUG1DPHILHOG
 )RUHDFK UHV RXUFH\RXZDQWWRDV V LJQWRWK HFD UGFOLFNWKHER[ EHQHDW K
W KHQDPHRI W K HUHVRXUF HWREHDV VLJQHGDQGWKHQFOLFN$GG
For example, if you click the box beneath IRQ, the button changes to Add Inter-
rupt. When you click this button, a Specify dialog box (in this case, Specify
Interrupt) appears. Figure 3-7 shows the Configure Unlisted Card dialog box with
the Specify Interrupt dialog box opened.
)LJXUH6SHFLI \,QWHUU XS W'LDORJ%R[