CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
1. Follow the procedures in "Before You Begin."
2. Disconnect the computer power cable from the electrical outlet.
3. Remove the front-panel door by gently snapping it off the two hinge arms.
4. Remove the front-panel insert above the door bay area by pulling the bottom of the insert with your fingers.
1 front-panel insert
2 use fingers to pull here
5. Lift both hinge arms to the horizontal position.
6. Use the two view slots to align the pivot bar with the two pivot-bar slots.
To Next Page
Loading...
