Wedge your fingers between the rear cover and the
middle bezel on the corners of the top side of the
monitor to release the rear cover, then use one hand
to press the middle bezel, the other hand to pull up
carefully the rear cover in order of arrow preference
for unlocking mechanisms of rear cover..
Use a Philips-head screwdriver to remove four
screws for unlocking mechanisms.
(No.1~4 screw size=M4x10; Torque=12±0.5kgfxcm)
S6
Take out all of the QSG,accessories including DP
cable, power cable, USB cable, CD&user’s manual,
stand and EEI label(optinal) from the carton from the
carton.(Note: It depends on whether users returning
the accessories)
S2
Open the Pizza carton with a proper tool.
1. Disassembly Procedures:
Lift the rear cover up carefully. Disconnect the key
cable and USB FFC cable from the connectors of
the interface board, and then remove the rear cover.
S6
S5
S1
Take out of the Paper-top from the carton, then take
out the packed monitor and packed stand from the
Pizza box.
S3
Take out the monitor from the bag and put it on a
protective cushion.
S4
2
3
4
1
1
DELL P2722H
1
3
2
2
QSG
base
user’s manual
DP cable
USB cable
power cable
stand
monitor
To Next Page
Need help?
General
