Dell PowerEdge FX2 - Page 71

Figure 59. Removing and installing the cable tubes
1.
screw on the KVM cover 2. KVM panel cover
3. Hex screw on the KVM panel (2) 4. KVM panel board
5. cable tube on the left side of the chassis 6. screws on the cable tubes (6)
7. tabs on the cable tubes 8. control panel cable
9. KVM panel cable 10. cable tube on the right side of the chassis
12. Push the KVM cable latch vertically up to disconnect the cable from the connector on the midplane.
13. Disconnect the control panel cable connector from the connector on the midplane.
Installing and removing PowerEdge FX2/FX2s enclosure components
71