Dell PowerEdge R730xd - Page 20

20 Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0
OS10EE Spine
Set the hostname, configure the OOB management interface and default gateway.
Z9100-ON Spine 1
Z9100-ON Spine 2
configure terminal
hostname Z9100-Spine1
interface mgmt 1/1/1
no ip address dhcp
no shutdown
ip address 100.67.169.37/24
management route 0.0.0.0/0 100.67.169.254
configure terminal
hostname Z9100-Spine2
interface mgmt 1/1/1
no ip address dhcp
no shutdown
ip address 100.67.169.36/24
management route 0.0.0.0/0 100.67.169.254
Configure the four point-to-point interfaces connected to leaf switches. In this example, each of the
connections from the Z9100-ON spine to the S4048-ON leaf switches needs to have the speed set to 40GbE.
Next, assign IP addresses per Table 3. Configure a loopback interface to be used as the router ID. Isilon’s
OneFS supports and recommends the use of jumbo frames. Each interface used below will be configured
using jumbo frames.