22 Cabling Your Cluster Hardware
b
Install a network cable from the cluster node 1 iSCSI NIC 2 (or NIC
port 2) to the RAID controller module 1 port In-1.
2
Connect cluster node 2 to the storage system:
a
Install a network cable from the cluster node 2 iSCSI NIC 1 (or NIC
port 1) to the RAID controller module 1 port In-0.
b
Install a network cable from the cluster node 2 iSCSI NIC 2 (or NIC
port 2) to the RAID controller module 0 port In-1.
3
If applicable, connect node 3 to the storage system. Node 3 can be either
cluster node 3 of the only cluster in the configuration, cluster node 1 of the
second cluster, or a stand-alone server.
a
Install a network cable from the cluster node 3 iSCSI NIC 1 (or NIC
port 1) to the RAID controller module 0 port In-2.
b
Install a network cable from the cluster node 3 iSCSI NIC 2 (or NIC
port 2) to the RAID controller module 1 port In-3.
4
If applicable, connect node 4 to the storage system. Node 4 can be either
cluster node 4 of the only cluster in the configuration, cluster node 2 of the
second cluster, or a stand-alone server.
a
Install a network cable from the cluster node 4 iSCSI NIC 1 (or NIC
port 1) to the RAID controller module 1 port In-2.
b
Install a network cable from the cluster node 4 iSCSI NIC 2 (or NIC
port 2) to the RAID controller module 0 port In-3.
book.book Page 22 Monday, June 21, 2010 1:45 PM
To Next Page
Loading...
