Getting Started With Your System 9
NIC Configuration
In a SAN environment, depending on the number of switches, it is
recommended that you use two or four unique subnets for iSCSI traffic.
For direct-attached storage environments, each NIC directly connected to
the MD32xxi must be on a separate subnet.
Installation and Configuration
WARNING: Before performing the following procedure, review the safety
instructions that came with the system.
Unpacking the System
Unpack your system and identify each item with the packing list that shipped
with your system.
Installing the Rails and System in a Rack
Assemble the rails and install the system in the rack following the safety
instructions and the rack installation instructions provided with your system.
NOTE: To balance the weight load, it is recommended that you install the
PowerVault MD32xxi at the bottom of the rack and the PowerVault MD12xx
expansion enclosures above it.
To Next Page
Loading...
